MOUNTING
Wall Mounting • Pre-drill all holes slightly oversized to allow for expansion and contraction. Galvanized, stainless steel or aluminum bolts, nuts and washers should be used to minimize contact and minimize corrosion. • Include washers or spacers between the panel and mounted surface so water does not get trapped behind the panel. Use lock nuts with washers to prevent the nuts from loosening over time. • Avoid over - tightening screws or bolts, over-tightening may damage the panel. • Pre-drill mounting holes at ground level first, then anchor and drill a single corner-mounting hole into the wall. Insert caulk into the corner-mounting hole. • Hang the sign by one corner and level it. • Level the sign again and place second anchor. The sign is now supported by the top corner screws. Drill the bottom holes, caulk, and insert anchors. Simple Frames with Extrusions • Measure and cut aluminum extrusions to proper size. • If necessary, paint extrusion desired color, follow paint manufacturer recommendations. • Install 3 sides of extrusion on wall and screw back leg of channel to wall with low profile pan-head screws. • Insert sealant inside all 3 extrusions to completely cover panel edges once inserted for proper seal. • Slide panel into installed channels. • Fill last extrusion with sealant and insert extrusion into panel on wall to finish framed look. Post and Panel • Assemble post and panel system following manufacturer guidelines. • Post and panel supports are normally 3' into the ground, 3' above the ground, and 4' for the sign. Do not extend sign beyond post and panel supports in excess of 9" for plastic core products and 12" for wood core products. • Fasten 2x4 stringers to two 4x4 pretreated posts, putting them into the ground and attach the sign to the stringers. • Paint two 2x4s and two 4x4 pieces with exterior paint. • Screw the 2x4s to the 4x4s. • Mount your sign while the framework is flat on the ground. • Dig post holes.
To order from Glantz , call or visit us online today! 1.866.645.2689 • NGLANTZ.COM
82023
Powered by FlippingBook