S I G N
EXTRUSIONS
A N D
S Y S T E M S
Step 6: Installation of faces. Trim the face 1/2” smaller than the overall height and width of the sign box. This will allow sufficient room for the face to expand and contract. The use of a hanging bar is recommended to keep the weight of the face off the bottom section of the cabinet. The hanging bar can be made from the same material as the face and can be attached either by bonding or mechanically fastening it. Assembly instructions for Standard 1Part / 2Part Single Face kits
7/8"
Hanging Bar Tab
(fig. D)
(fig. E)
Step 7: Cut a 7/8” wide strip of material and place strip on the back side of the face. Align the strip with the top edge of the face and bond or mechanically fasten. (see fig. H) Note: If the hanging bar is bonded to the face make sure to allow adequate time for the adhesive to dry before the face is installed. Remove the 2Part Retainer, place hanging bar on the tab and slide face into place. (see fig. I) Install 2Part Retainer back on sign box.
1Part 2Part Body Corner Angle
1Part S/F Body
2Part S/F Body
Standard Corner Key
2Part Retainer
For any questions or concerns with your kit, please call SignComp toll free at 1-877-784-0405 or email us at signcomp@signcomp.com.
Powered by FlippingBook