S I G N
EXTRUSIONS
A N D
S Y S T E M S
Step 3: Attach the retainers to the body. Locate along the scribe line and starting 2’ in from the end, using an 1/8” drill bit, drill a pilot hole through retainer into the body as shown. (see fig. D) Repeat at opposite end. Evenly place the remainder of the retainer screws in between end screws approximately 12” on center. Attach retainer using the #8 x 1/2” hex head screws provided as shown. (see fig. E) Assembly instructions for Standard 1Part / 2Part Single Face kits
(fig. D)
(fig. E)
Step 4: Install internal supports as necessary for the type of installation required. Note: Internal supports are not provided in kit.
Step 5: Attach raceway covers. Depending upon which direction the lamps will run (horizontal or vertical), raceway covers are made 1-3/4” long so that they can be trimmed to fit (see fig. F) or be bent to roll up the adjacent sides. (see fig. G) If corners have been welded or mechanically fastened you will need to notch out around the weld or the screw so that the raceway cover will lay flat and slip into the raceway cover tab. Push one side into the raceway cover tab and fasten (fasteners not included) the other side down as shown below.
(fig. F)
(fig. G)
Powered by FlippingBook