3M™ Protection Wrap Film
Product Bulletin Protection Wrap Film Revision A, April 2024
Characteristics The following technical information and data should be considered representative or typical only and should not be used for specification purposes. Physical Characteristics
Characteristic
Value
Material
Polyurethane
Film with adhesive: 7.5 mil to 9 mil (0.19 mm to 0.23 mm), depending on color Release liner: 6.4 mil (0.16 mm) Cap sheet: 2.0 mil (0.05 mm) Pressure-sensitive adhesive, repositionable with air release channels
Thickness
Adhesive
Adhesive Color
Clear
Typical Adhesion 20 Minutes After Application
Painted panel: 2.1 lbf/in. (3.7 N/cm)
Protective Cap Sheet
Clear polyester
Liner
Polyethylene-coated PET
Flammability standards are different from country to country. Contact a local 3M representative for details.
Flammability
Application Characteristics
Characteristic Substrate Type
Value
Painted surfaces*
60°F to 85°F However for optimal application, 3M recommends installing at 65°F to 75°F (18.3°C to 23.9°C).
Application Temperature
Application Method
Dry
* Check the film’s adhesion to powder-coated or water-based paints.
!
NOTE This film is NOT recommended for use on stainless steel substrates, nor warranted for stainless steel applications. Contact a 3M sales representative for information about more appropriate products.
Factors Affecting Performance Life The actual performance life of a protection wrap is affected by: • Selection and preparation of the substrate • Surface texture • Application methods • Angle and direction of sun exposure • Environmental conditions • Cleaning and maintenance methods
2
Powered by FlippingBook