TM
LIMITED WARRANTY (continued)
SELLER EXPRESSLY DISCLAIMS ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE AND WARRANTIES AND/OR INDEMNITIES AGAINST INFRINGEMENT OF ANY INTELLECTUAL PROPERTY RIGHTS. REGARDLESS OF THE FORM OF THE CLAIM OR CAUSE OF ACTION, WHETHER BASED IN CONTRACT, INFRINGEMENT, NEGLIGENCE, STRICT LIABILITY, TORT OR OTHERWISE, SELLER WILL NOT BE LIABLE TO BUYER OR ANY OTHER PARTY FOR DIRECT, INDIRECT, SPECIAL, INCIDENTAL, CONSEQUENTIAL, EXEMPLARY OR PUNITIVE DAMAGES, INCLUDING WITHOUT LIMITATION, LOSS OF PROFITS, LOSS OF USE, COSt OF LABOR, AND COST OF CAPITAL. Without limiting the generality of the foregoing, Seller’s liability will in no event exceed the original purchase price of the defective beBond TM Product. The foregoing limitations of liability represent the allocation of risk between the parties as reflected in the pricing of goods offered by Seller, and are an essential element of the basis of the bargain between the parties. Some states do not allow limitations on how long an implied warranty lasts and/or do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations may not apply to certain Buyers. This Limited Warranty gives the Buyer specific legal rights, and the Buyer may also have additional rights which vary from state to state.
NOTE: UV adhesion varies, a test print is recommended. For best results when printing on aluminum composite materials, please read below.
Printing • Select Aluminum Composite when configuring and loading this media. • M edia placement detection is disabled when using this media type. When loading the media, it is necessary to enter the location of the left (user side) and right (service side) edges of the media according to the Media Measurement Option selection. • If the edges are bent, they should be flattened before imaging. A head height higher than the standard 0.085 inches (2.2 mm) may be necessary to avoid damaged or bowed edges that will interfere with the path of the carriage. • U se an Aluminum Composite media profile from the RIP software. • F or increased saturation on non-white or brushed aluminum surfaces, use the RIP software’s Saturated Rendering Intent option or select a Max DPI print mode. Output handling • Use caution when loading or lifting sheets off the table as the media and ink can be easily scratched.
Preparation • P eel the protective film off one side in one continuous peel- do not start/stop during removal. • A lways wipe the surface with 88% or higher IPA on a lint-free cloth to remove dust or debris. Allow the sheet to sit out on the input table about five minutes to allow the IPA to evaporate and the static to dissipate. • W ipe the printing surface with an anti-static tack cloth to remove static charge and any dust or debris. • E nsure the media is flat and there are no damaged corners, edges or ends. Recommended print modes
• Indoor Signage Plus • Photo or Photo Plus • F or increased saturation, use Max DPI –Saturated.
866.645.2689 • nglantz.com
Powered by FlippingBook